Top pick: a super-clone 116613LB with a wrapped 18k gold bezel, wrapped center links, a clone 3135 movement, and a 904L case. That tier is the only replica build where the gold tone, ceramic insert depth, and date magnification come close to the genuine Submariner on a side-by-side check at arm's length. Everything below weighs each option on five points: gold content, bezel insert, movement, case and bracelet finishing, and real water resistance.

fake rolex 116613 used for sale

Top pick: super-clone 116613LB with wrapped gold

This is the tier to buy if the goal is a convincing Bluesy on the wrist rather than a cheap stand-in. The bezel and center links use wrapped gold, which carries a layer several times thicker than electroplating, so the color stays warm instead of turning copper under indoor light. The case is machined to 40 mm with crown guards that match the genuine profile, and the bracelet gets solid end links that sit flush against the lugs. Movement is a clone 3135 with a free-sprung balance and a date change that snaps rather than drags.

Replica Rolex 116613 Swiss Movement: What It Means

Pros

Rolex 116613 Super Clone Two Tone: What Buyers Should Check

• Wrapped gold on bezel and center links, so the yellow tone holds up to daily wear
• Clone 3135 gives the correct crown position, hand stack, and 28,800 vph sweep
• Ceramic insert with gold-filled numerals recessed at roughly the right depth
• Solid end links and a working Glidelock-style extension in the clasp

Cons

Buying a Fake Rolex 116613: Check the Gold Before the Movement

• Most expensive replica tier, often within a few hundred dollars of a used entry-level Swiss watch
• 904L is claimed more often than delivered, so ask for a written spec sheet
• Water resistance is stated, rarely pressure tested before shipping

Buy this one if you want the closest visual match and you accept that service and parts support sit with the seller, not with Rolex.

Genuine Rolex Submariner 116613LB

The real reference runs a 40 mm Oyster case in Oystersteel and 18 ct yellow gold, a blue Cerachrom insert with gold-coated numerals, caliber 3135 with a 48-hour reserve, and 300 m of rated water resistance. Gold is solid, not layered, so polishing over decades never exposes a base metal. The dial uses Chromalight lume that still glows after ten years, the cyclops magnifies at 2.5x with anti-reflective coating underneath, and the rehaut engraving is crisp and centered at every hour marker.

Pros

• Solid 18 ct gold bezel and center links that age instead of wearing through
• Caliber 3135 with documented service history and Rolex parts support
• 300 m water resistance you can trust in the water
• Holds value, and the serial and papers are verifiable

Cons

• Costs many times more than any replica tier
• Service intervals and polishing costs add up over a long ownership
• Gold surfaces scratch, and bracelet stretch shows after years of daily wear

Buy this one if resale value, warranty, and actual dive-rated water resistance matter more than the entry price.

Mid-tier replica with plated gold

A step down, this build uses gold plating in the 3 to 5 micron range over a 316L case, usually with an A2824 or 2836 movement and a modified date wheel. The shape is close, the insert is ceramic, and the bracelet feels solid, but the gold reads slightly brassy in fluorescent light and the plating thins at the clasp edges within a year of daily wear. The date font tends to sit a touch left of center, and the cyclops shows more distortion than the genuine crystal.

Pros

• Roughly half the cost of the super-clone tier
• Reliable ETA-clone movement that any watchmaker can service
• Good enough for photos and occasional wear

Cons

• Plating wears through at contact points, and the fix is a re-plate or a new bracelet
• Insert numerals are painted, not gold-filled, and look flat in low light
• Lume is weak and fades within an hour

Buy this one if you want the look for occasional wear and you are not chasing a side-by-side match.

Budget replica

At this level the watch is a silhouette of the 116613LB. The case is thicker through the mid-case, the crown guards are rounded off, the bezel insert is aluminum or a printed ceramic with a bright, flat blue, and the gold is a thin flash plating over brass or 316L. The movement is a low-grade automatic with a stuttering sweep, and the bracelet rattles at the end links.

Pros

• Lowest entry cost by a wide margin
• Fine as a costume piece or a beater for rough trips

Cons

• Gold tone is obviously off next to any real two-tone watch
• No meaningful water resistance, and gaskets are often dry from the factory
• Date magnification and dial printing are visibly wrong

Buy this one only if the watch is disposable to you and the setting is casual.

What actually separates a replica 116613 from the genuine

Gold content

Genuine Rolesor uses solid 18 ct gold for the bezel and center links. Replicas split into plating, wrapping, and solid gold. Wrapping is the practical middle ground, plating is the weak point, and solid gold replicas exist but cost close to a used genuine and are hard to verify.

Bezel insert

The genuine Cerachrom insert is one piece of blue ceramic with recessed numerals filled with gold via PVD. Replicas use ceramic with painted or gold-filled numerals. Look at the depth of the numerals and the edge transition at the bezel rim.

Movement and crown

The genuine caliber 3135 winds smoothly, hacks, and changes the date with a clean snap. Clone 3135 movements copy the layout but vary in finishing and long-term accuracy. The crown should thread cleanly and seat flush against the case.

Case and bracelet finishing

Genuine brushed surfaces run in one direction with tight, even graining. On a replica, check the transition between brushed lugs and polished flanks, the gap at the solid end links, and the clasp stamping depth.

Water resistance

The genuine is rated to 300 m and tested. A replica may pass a 3 atm pressure test, but no seller pressure tests every unit. Treat any replica as splash resistant unless a watchmaker tests it for you.

Who should buy which

For a daily-worn Bluesy that has to pass a close look, the wrapped-gold super clone is the pick, and the clone 3135 is worth the premium over an ETA clone. For occasional wear and photo use, the plated mid tier covers the look at half the cost. For buyers who care about resale, service history, and real dive capability, the genuine 116613LB is the only option that delivers all three. Skip the budget tier unless you treat the watch as a disposable accessory.